Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 1212) Press qw to switch the item.f The items will switch each time you press the button.[DISABLE] Disables the No signal shut-off function.[10MIN.] - [90MIN.] Allows you to set in ten minutes intervals.[REMOTE2 MODE]You can set the terminal.1) Press as to select [REMOTE2 MODE].2) Press qw to switch the item.f The items will switch each time you press the button.[DEFAULT] The pin assignment of the terminal is used by the factory default setting of theprojector.[USER] Used to change the setting of the terminal.[L6500 SERIES] The setting of terminal is used for the L6500 series compatibility.f When [USER] is selected, proceed to Step 3).3) Press the button.4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.[FUNCTION BUTTON]Set the functions of the button on the remote control.1) Press as to select [FUNCTION BUTTON].2) Press the button.f The [FUNCTION BUTTON] screen is displayed.3) Press as to select a function.[DISABLE] Disables the button.[P IN P] Switches the [P IN P] setting to [OFF], [USER1], [USER2], or [USER3]. (x page 124)[SUB MEMORY] Displays the sub memory list. (x page 129)[SYSTEM SELECTOR] Switches the [SYSTEM SELECTOR] setting. (x page 76)[SYSTEM DAYLIGHT VIEW] Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 74)[FREEZE] Temporarily pauses the image. (x page 105)[WAVEFORM MONITOR] Displays the waveform of the input signal. (x page 105)[LEFT/RIGHT SWAP] Switches the flip horizontal settings. (x page 92)[ASPECT] Switches the aspect setting. (x page 78)4) Press the button.[DATE AND TIME]Set the time zone, date, and time of the built-in clock of the projector.Setting the time zone1) Press as to select [DATE AND TIME].2) Press the button.f The [DATE AND TIME] screen is displayed.3) Press as to select [TIME ZONE].4) Press qw to switch [TIME ZONE].
