Panasonic PT-FW300NTU Operating Instructions Manual

Also see for PT-FW300U - LCD Proj Wxga 600:1 3500 Lumens Enet 13.7LBS H/v Lens: Brochure & specs Dimensions Service manual Service manual Specifications

Contents

ENGLISH - 35 SettingsPOSITION menuIf the projector is aligned non-perpendicularly to thescreen, or if the projection screen has an angled surface,you can correct keystone.You can move the projected image for fine adjustment.Press I H to move horizontally and F G vertically.(Not available with NETWORK signals)When H-FIT setting in ASPECT menu is selected, youcan move the projected image vertically for fineadjustment by pressing I H. (Available with signalsfrom NETWORK only)If you have interference patterns of the projected image,which is sometimes referred to as moire or noise, youcan minimize it by pressing I H to adjust the clockfrequency. (Available with signals of RGB/DVI still only)If you require further adjustment for the same reason asthe DOT CLOCK adjustment, you can fine adjust thetiming of the clock. Press I H to adjust. (Available withsignals of RGB/DVI still only)If the 4 edges of an image is partly dropped, you can usethis function to adjust and project it properly. (Notavailable with signals of NETWORK)I ShrinkH EnlargeKEYSTONEImage OperationNOTE:• You can correct the distortion ± 30 degrees from theplane. For a better quality image, installing the projectorwith a minimum of distortion is recommended.• Some distortion may be retained for lens shiftadjustment.• The distortion of the main menu screen is notcorrectable.• The result of the keystone correction will affect theaspect ratio and the size of the image.SHIFTRemote control Control panelSee “Navigating through the menu” on page 32.See “Main menu and Sub-menu” on page 30.SHIFT HVSHIFT VDOT CLOCKNOTE:• If the projecting signal’s dot clock frequency is higherthan 150 MHz, the adjustment may not make adifference.• DOT CLOCK needs to be adjusted before adjusting theCLOCK PHASE.CLOCK PHASENOTE:• If the projecting signal’s dot clock frequency is higherthan 150 MHz, the adjustment may not make adifference.OVER SCAN