ENGLISH - 48MaintenanceCare and ReplacementJ Before cleaning the projectorSwitch off the MAIN POWER and disconnect the power plug from the wall outlet.Unplug all the cables from the projector.J Cleaning the outer surface of the projectorWipe off dirt and dust gently with a soft cloth.If it is difficult to remove the dirt, soak a cloth with water, wring the cloth well and then wipe the projector.Dry off the projector with dry cloth.If you use a chemical treated wipe, follow the instructions supplied with it.J Cleaning the lens and front glass surfaceWipe off dirt and dust gently with a lint-free cloth.Make sure no dirt or dust remains on the surface of the lens. It will be enlarged and projected onto ascreen.J Before replacing the Lamp unitSwitch off the MAIN POWER and disconnect the power plug from the wall outlet.Wait for more than 1 hour and make sure the lamp unit and the surroundings are cooled enough.Prepare a Phillips-head screwdriver.Contact an Authorized Service Center to purchase a replacement lamp unit (ET-LAF100).When the projector is mounted on the ceiling, do not work directly under the projector or put your facecloser to the projector.J When to replace the lamp unitThe lamp unit is consumable and the brightness decreases by duration of usage. The LAMP indicator willinform you of the replacement timing at 5 000 hours, and at 6 000 hours, the projector will be turned off. Thosefigures are rough guidance and might be shortened by the usage conditions, characteristics of the lamp unit,environmental conditions, and so on. You can check the duration of usage time using RUNTIME of STATUS inthe PROJECTOR SETUP menu.Cleaning the projectorReplacing the Lamp unitNOTE:• Prior to replacing the lamp unit, allow it to cool down to prevent the risk of burns, damage and other hazards.• Do not attempt replacement with an unauthorized lamp unit.IndicationOn screen LAMP indicatorOver 5 000 hours “REPLACE LAMP” is displayed on theupper left of the screen for 10 minutes.Illuminates red.Over 6 000 hours“REPLACE LAMP” is displayed on theupper left of the screen, and it will stay untilyou respond.To clear the screen, press any button.NOTE:• The guide times, 5 000 and 6 000 hours, are rough estimates based on certain conditions and are not a guaranteed time.• For more information about the lamp unit, such as guaranteed time, see the instructions which is provided with the lampunit.REPLACE LAMP