Panasonic PT-FW300NTU Operating Instructions Manual

Also see for PT-FW300U - LCD Proj Wxga 600:1 3500 Lumens Enet 13.7LBS H/v Lens: Brochure & specs Dimensions Service manual Service manual Specifications

Contents

ENGLISH - 44SettingsSECURITY menuJ Entering the SECURITY menuEvery time when you apply to the SECURITYmenu, you will be asked to perform the passwordoperation.When you apply to the SECURITY menu before youchange the password to your original, perform to inputthe following factory default password operation.Press F H G I F H G I and the ENTER button.Q After you change the passwordWhen you apply to the SECURITY menu after youchange the password to your original in thePASSWORD CHANGE menu, input the originalpassword operation.You can activate the security system and the passwordoperation will be asked to perform when the projectingmode started. Unless you perform the correct passwordoperation, all of the button controls will be disabledexcept the power button.OFF DeactiveON ActiveYou can change the password operation to your original.1. Press a series of button operation up to 8 as apassword by using F G I and H.2. Press the ENTER button.3. Press the exact same series of button operationyou entered in the NEW password box forconfirmation.If a series of button operation is incorrect, you will beasked to perform again.4. Press the ENTER button.You can set your original text, such as company name orURL information, to display regularly at the bottom of theprojected image while projecting.OFF DeactiveON ActiveYou can enter your original text up to 22 characters forTEXT DISPLAY.1. Enter your original text.Use F G I H to specify the location of the requiredcharacter.Move the cursor to ALL DELETE and press theENTER button to delete all the entered text line.Press the DEFAULT button to delete the last enteredcharacter or indicated with the cursor in the text line.To insert a character in the entered text line, movethe cursor to the text box to select the required placeand press G then perform step 2.2. Press the ENTER button.The selected character will be displayed in the TEXTCHANGE box.3. Repeat until finish your original text.4. Select OK and press the ENTER button to set theentered text.Select CANCEL or press the MENU/RETURNbuttons to return to the previous menu.NOTE:• The factory default password is valid until you changethe password in PASSWORD CHANGE menu.• The entered password operations will appear asasterisks in the box.PASSWORDNOTE:• When you activated the security system, make sure tochange the password to your original for safety.• The factory default password is valid until you changethe password in PASSWORD CHANGE menu.Remote control Control panelSee “Navigating through the menu” on page 32.See “Main menu and Sub-menu” on page 30.PICTUREPOSITIONPASSWORDPASSWORD CHANGETEXT DISPLAYTEXT CHANGEMENU LOCKMENU LOCK PASSWORDCONTROL DEVICE SETUPPASSWORDLANGUAGEPROJECTOR SETUPDISPLAY OPTIONSECURITYNETWORKOFFOFFOFFENTERRETURNPASSWORD CHANGENOTE:• The entered password operations will appear asasterisks in the box.TEXT DISPLAYTEXT CHANGEOK CANCELALL DELETETEXT CHANGESPACE