16%%%%% Select and click Stop Standard IDE/ESDIHard Disk Controller or Stop BN-SDSeriesPCMCIA Disk Controller.&&&&& The screen shown at right will appear. ClickOK to remove the PC card adapter.((((( Press the eject button of the PC cardadapter and take out the SD memory card.Note:B Be sure to follow the removal procedurecorrectly. If the correct procedure is notfollowed, it may result in damage to the cardor loss of data on the card.Using the SD memory card in a MacintoshThe accessory PC card adapter can be used to insert the SD memory cardinto a Macintosh with a built-in PC (PCMCIA) card slot which is either Type IIor Type III compatible. You can then save images from the Macintosh onto theSD memory card and edit these images.Inserting the SD memory card##### Insert the SD memory card into the PCcard adapter as shown in the illustrationat right.Push the card in until it locks into place.Make sure that it is facing the correct way.Note:B If the SD memory card is inserted into a Macintosh using the PC cardadapter while the write-protect switch is at the LOCK position, it will take along time (a few minutes depending on the case) for the Macintosh torecognise the card, and an error message may appear. If this happens,take the SD memory card out of the Macintosh by following the steps onpage 18, and change the position of the write-protect switch so that it isnot at the LOCK position.CARDEject buttonCARDPC card adapterSD memory card