Panasonic PT-LB51SU Operating Instructions Manual

Also see for PT-LB51EA: Brochure & specs Service manual

Contents

Panasonic PT-LB51SU Operating Instructions Manual Manual pdf 20 page image

ENGLISH - 20Basic OperationSwitching the projector on/offJ Connecting1. Make sure the shape of the power cord plug and the AC IN connector on the backof the projector match, then push the plug all the way in.2. Connect the Power cord to a wall outlet.J Disconnecting1. Check that the POWER indicator of the POWER button is lit red, and then unplug the Power cord from thewall outlet.2. Hold the plug and unplug the Power cord from the AC IN connector on the back of the projector.J Direct power off functionYou can disconnect the Power cord during projection or immediately after use and move the projector. Thecooling fan will operate by the internal power supply to cool down the lamp.When this function is used, it may take more time for the lamp to turn back on again compared to when the lamp coolsdown with the Power cord connected.Do not put the projector in a bag while the POWER button on the projector is illuminated.J Direct power on functionIf you activate the DIRECT POWER ON, you can start the projection only with connecting the Power cord.See “DIRECT POWER ON” on page 35.Power cordNOTE:• Do not use other than a provided Power cord.• Ensure all the input devices are connected and turned off before connecting the Power cord.• Do not force the connector as this may damage the projector and/or the Power cord.• Dirt or dust build-up around plugs may cause fire or electrical hazards.• Switch off the power to the projector when not in use.POWER indicatorIndicator status StatusRED LitThe projector is in standby.When the LAMP or TEMP indicator is flashing, the POWER indicator willnot be lit.GREENFlashing The POWER is switched on and the projector is getting ready to project.Lit The projector is ready to project.ORANGELit The POWER is switched off and the projector is cooling the lamp.Flashing The POWER is switched on again when cooling the lamp and recoveringto projection mode. Recovery may take a while.NOTE:• If the projector is switched on again while the internal cooling fan is still operating by the internal power supply, it may takea while to start the projection.• The electric consumption in standby mode is 4 W.POWER indicator