Panasonic PT-LB51SU Operating Instructions Manual

Also see for PT-LB51EA: Brochure & specs Service manual

Contents

Panasonic PT-LB51SU Operating Instructions Manual Manual pdf 30 page image

ENGLISH - 30SettingsPICTURE menuDepending on the projection environment, you can usethese preset parameter settings to optimise imageprojection. Press I H to cycle through the options.You can adjust the contrast of the projected image.Adjust the BRIGHTNESS in advance if necessary.You can adjust the brightness of the projected image.(S-VIDEO/VIDEO/COMPONENT signals only)You can adjust the color saturation of the projectedimage.(NTSC/NTSC 4.43/COMPONENT signals only)You can adjust the skin tone in the projected image.You can adjust the sharpness of the projected image.You can adjust the white balance of the projected image.LOW More bluishSTANDARD Balanced whiteHIGH More reddishPICTURE MODESTANDARD Setting for a general imageDYNAMIC Bright and sharp settingBLACKBOARDSetting for when projecting ona blackboardSee “BLACKBOARD” onpage 36.NATURAL Reproduces the original colorof the imageNOTE:• It may take for a while until the selected mode isstabilised.• When FUNCTION BUTTON is set to "PICTUREMODE" (see “FUNCTION BUTTON” on page 34), thePICTURE MODE operation can also be carried out bypressing the FUNCTION button at the front of theprojector.CONTRASTBRIGHTNESSRemote control Control panelSee “Navigating through the MENU” on page 27.See “Main menu and Sub-menu” on page 28.HigherLowerBrighterDarkerCOLORTINTSHARPNESSCOLOR TEMPERATUREProjecting sRGBcompatible picturessRGB is an international color reproduction standard(IEC61966-2-1) established by the InternationalElectrotechnical Commission (IEC).If you would like the colors in sRGB-compatible picturesto be reproduced more faithfully, make the followingsettings.1. Press the F or G button to select “PICTUREMODE”, and then press the I or H button toselect “NATURAL”.2. Press the DEFAULT button on the remote controlunit.3. Press the F or G button to select “COLORTEMPERATURE”, and then press the I or Hbutton to select “STANDARD”.NOTE:• sRGB is only enabled when RGB signals are beinginput (when “LAMP POWER” is set to “STANDARD”,“AI” is set to “OFF”, and “DAYLIGHT VIEW” is set to“OFF”).DarkerLighterMoregreenishMorereddishMoresharpLesssharp