Playback Mode-37-Playback ModePlaying Back a TapeThe recorded scene can be played backimmediately after the recording.1 Set the [OFF/ON] Switch (46) to [ON].≥The [POWER] Lamp (47) lights up.2 Set the Mode Dial (43) to Tape PlaybackMode.3 Press the [6] Button (16) to rewind thetape.≥Rewind the tape to the point where you wantto start playback.≥When the tape reaches the beginning,rewinding stops automatically.4 Press the [1] Button (14) to start playback.≥The [!] Indication appears.≥If a cassette recorded with a copyrightprotection signal is played back, the picture isdistorted by mosaic-like patterns.To Stop PlaybackPress the [∫] Button (15).ONOFFPOWER(46)(47)PCSD(43)STILLENTERFADEis(16)STILLENTERFADEis(14)(15)STILLENTERFADEisª Adjusting the Sound VolumeTo adjust the volume, push the [W/T] Lever (40)to display the [VOLUME] Indication. Push the[W/T] Lever towards [T] to increase the volume orpush the [W/T] Lever towards [W] to decrease thevolume. The [VOLUME] Indication goes off afterthe adjustment is finished.To adjust the volume with the Remote Controller,press the [T] or [W] Button to display the[VOLUME] Indication. Press the [T] Button toincrease the volume or press the [W] Button todecrease the volume. The [VOLUME] Indicationgoes off after the adjustment is finished.≥The sound volume cannot be adjusted using theRemote Controller in Playback Zoom Mode.(-39-)≥For other notes concerning this item, see -67-.Finding a Scene You Want to PlayBackª Cue/Review PlaybackIf the [5] Button (13) or [6] Button (16) ispressed during Playback, it turns to Cue PlaybackA or Review Playback B.≥If the Button is held continuously, it turns to CuePlayback or Review Playback until you releaseit.VOL/JOGW T(40)STILLENTERFADEis(16) (13)A B