Panasonic PV-V464S Operating Instructions Manual

Also see for PV-V464S: Service manual Operating instructions

Contents

*Important: IpInsert pre-recorded taPress PLAY to start dPlaying VCR starts plTo Monitor Dubbing o1 Turn your TV on and tVCR channel (CH3 or2 Set the VCR/ TV SeleVCR to “VCR.”• Dubbing tapes pGuard will havePress STOP to stop dPress PLAY, then PAimmediately to enter PConnectionPlaying (Sour12345Caution : Unauthorizedcopyright infr(Rear connection shown.)NoteCopying YoBefore Requesting ServicePowerNo power…Recording & PlaybackTV program cannot be recorded...Timer recording cannot beperformed…There is no playback picture, or theplayback picture is noisy or containsstreaks...Special effects playback picture maycontain some vertical jitter when usinga TV with an Automatic Vertical HoldControl...VCR cannot be controlled...Check the following points once again if you are having trouble with your VCR.(BO : refers to “Basic Operations” Instruction book.)(AO : refers to “Advanced Operations” Instruction book.)Correction• Completely insert Power Plug into an AC outlet.• Press POWER button on.• Make sure power source is active.MiscellaneousPrograms cannot be viewed on TV...Video cassette cannot be inserted...Video cassette cannot be removed...Video cassette ejects when arecording is started or the power isturned off for timer recording...In Stop mode, the motor (CYLINDER)continues to rotate...Remote ControlVCR cannot be remote controlled...ACTION and PROG buttons do notrespond...If you cannot resolve the problem, please call the Customer Call Center for productassistance at 1-800-211-PANA (7262).To locate an authorized servicenter, please call toll free 1-800-211-PANA (7262).or, contact us via the web at:http://www.panasonic.com/contactinfoCorrection• Check connections between VCR, external antenna, and TV.• Check connections selection. (BO p. 4, AO p. 3)• Make sure your antenna system (CABLE or TV) is correctlyset. (Channels [AO p. 12])• Make sure cassette record tab is intact. (BO p. 3)• Confirm that clock is set to current time and date.• Make sure Cable/DSS box (if used) is left on and tuned tochannel to be recorded.• Set recording start/stop times correctly. (BO p. 6)• Make sure VCR POWER button is pressed off. (BO p. 6)• Timer recording may not be performed or continued if a powerinterruption occurs before or during a Timer Recording, evenafter power is restored.• Select channel 3 or 4 on TV to match VCR output channel (3 or4) (BO p. 4) or select LINE.• Set VCR/TV selector to “VCR.”• Adjust TRACKING control in either direction. (BO p. 3)• Try Head Cleaning. (BO p. 3)• Set TV’s Vertical Hold Control to MANUAL, then adjust.• Make sure VCR power is on.• Check Remote batteries.• Make sure VCR LOCK is set to off. (AO p. 10)• Make sure Timer Record is not in progress.Panasonic Consumer Electronics Company,Division of Matsushita Electric Corporation of AmericaOne Panasonic Way Secaucus, New Jersey 07094Panasonic Sales Company (“ PSC” ),Division of Matsushita Electric of Puerto Rico, Inc.Ave. 65 de Infantería. Km. 9.5 San Gabriel Industrial Park,Carolina, Puerto Rico 00985PCorrection• Make sure VCR power is on.• Make sure Remote is in VCR mode.• Aim Remote Control directly at remote sensor on VCR. (BO p. 7)• Avoid any object blocking signal path.• Check Remote batteries. (BO p. 3)• Make sure VCR LOCK is set to off. (AO p. 10)• Exposing VCR remote sensor to direct fluorescent or outdoorlight may cause signal interference.• Check connections between VCR, external antenna, and TV.• Press VCR button for VCR mode. (AO p. 2)• Check Remote batteries. (BO p. 3)Correction• Make sure TV power is on.• Make sure TV is tuned to VCR's output channel (3 or 4).• Check connections between VCR, external antenna, and TV.• Set VCR/TV selector to “TV.” (BO p. 5, AO p.10)• Make sure proper signal source is selected.• Insert the cassette with window side up; record tab facing you.• Check if a tape is already in the unit.• Confirm Power Plug is fully inserted into an AC outlet.• Make sure cassette record tab is intact. (BO p. 3)• To enable Quick play mechanism, the cylinder will rotate forabout 5 minutes. This reduces response time from Stop to Playmode and from Play to Rewind Search mode.- 8 -12Connect VIDEO OUT jaTo monitor the dubbingConnect AUDIO L/R OUIn place of a PlaySimply connect tVCR(HiFi)AUDIO OUTPrinted in IndonesiaLSQT0814 AS1203-1014The oand r