66External DisplayYou can switch the output destination to an external display.Before switching the computer on, connect the external display to theexternal display port (A) and the AC adaptor to the DC-IN jack (B) onthe Cradle.NOTEz After resuming from standby or hibernation, or restarting the computer, the output destination may not be the same asthe one selected in the previous status.z When you change the display after Windows starts up, do not press any button, key and screen until switching is com-plete.z Until Windows startup is completed (during Setup Utility, etc.), the switching function between the internal LCD and theexternal display.z “Full Screen” of [Command Prompt] is not supported.z Do not connect or remove the external display during standby or hibernation.z It may take some time to switch between displays depending on the displays used.z When you use high resolution displays, the display color, resolution or refresh rate may be changed, switching to [MID]in [Intel(R) Graphics Media Accelerator Driver for ultra mobile].We recommend you to switch the output destination by pressing [A1] button.z When you use the external display only, set the suitable number of colors, resolution, or refresh rate separately fromwhen you use the internal LCD only or when you use the simultaneous display. When you switch the display from theinternal LCD to the external display, the resolution of the external display become same as that of the internal LCD.Set the resolution again.Depending on the settings, some external displays may be distorted or may not display the mouse cursor correctly. Inthis case, set the settings to lower value.z When you use the simultaneous display, DVD-Video, MPEG files and other motion image files may not be played backsmoothly.z Carefully read the instruction manual of the external display.z When connecting an external display that does not conform to the Plug & Play standards, select the display driveraccordingly in the following menu, or use the driver disc supplied with the monitor.[start] - [Control Panel] - [Appearance and Themes] - [Display] - [Settings] - [Advanced] - [Monitor] - [Properties] -[Driver] - [Update Driver]z If a picture is not displayed normally, lower the level of [Hardware acceleration] in the following menu.[start] - [Control Panel] - [Appearance and Themes] - [Display] - [Settings] - [Advanced] - [Troubleshoot]AB