Jumping to Specified Point (Go To)OSpecifying the point to view1 Choose"Specify" in step 2 above, and then pressthe l,-/il button.The screen for specifying the point to go to willappear.Positionof currently Totalrecording time ofplayed back image all selected scenesCursor position2 Use the control buttons to select the desired timeof chosen point.Press the _ button :To select the start.Press the _ button : To select the end.Press the _ or _ button :-Press once: To move the cursor in 10-second units (1-still unitsfor card)-Hold down: To move the cursor in 1-minute units (10-still unitsfor card)QmmTop :To go to the start, and enter playbackpause.End :To go tothe end of last scene, and enterplayback pause.Specify :To go to a specified point and enterplayback pause. See the following fordetails.3 Press the ,/li button to enter the selection.The DVD Video Camera will go to the specifiedpoint and enter playback pause mode.Pressing _./11 again will start playback.To cancel the "Go To" procedure midway, press the• button before going to the specified point.Note:• If multiple scenes are selected using the Disc Navigationfunction or SELECT button, choosing "Top" will jump tothe beginning of selected scenes (R 123).• When multiple scenes are selected, the total time ofselected scenes will appear in the total recording time"display.• With card, the number of stills will appear at the "TOP".CURRENT", "END" and GO TO" indicators.• The cursor may not move at same-pitch intervals.(When the start of scene is selected)Cursor at current image position.m Cursor at (GO TO) position.52