Identifying ControlsQuick Start Guide9This LED is not indicated for this model.Using the On Screen DisplaysMany features available on this TV can be accessed via the On Screen Display menu.How to use remote controlMENU Open the main menu EXIT Exit the menu system and return tothe normal viewing screenMove the cursor / select the menu item Move the cursor / adjust levels /select from a range of optionsAccess the menu / store settings after adjustmentshave been made or options have been setRETURNReturn to the previous menuON SCREEN HELP Instructions box - Operation guide(example: Owner ID)Owner IDEXITRETURNPlease enter new PINPIN * * * *PIN entry0 9Operation guide will help you.Changes the input modeHeadphonesjack (p. 58)CI Slot(p. 46)TVMains power On / Off switch• Use to switch mains power On / Off.If TV was switched off whilst in Standby mode, using theMains Power On / Off switch, then it will be in Standby modewhen switched back on using the same switch.For changing TV channel up or down. When a function isselected by the ‘F’ button, press to increase or decreasethe setting of the selected function. When in Standbymode, press either button for about 1 second to switchthe TV On.Function selectVolume / Contrast / Brightness / Colour / Sharpness / Tint (NTSC signal) / Bass (“Music” or “Speech” mode in theSound Menu) / Treble (“Music” or “Speech” mode in theSound Menu) / Balance / Auto Setup (p. 34 and p. 35)SD Card slot(p. 48)Auto power standby function The TV will automatically go to Standby mode in the following conditions: no signal is received and no operation is performed for 30 minutes in Analogue TV mode•“Off Timer” is active in the Setup Menu (p. 17)•no operation is performed for the period selected in “Auto Standby” (p. 30)•This function does not affect Ext Rec. of Timer Programming and Direct TV Recording.Power and Timer LEDRed : StandbyGreen: OnOrange: Timer Programming OnOrange (flash): Ext Rec. of Timer Programming or Direct TV Recording in progressRed with orange flash: Standby with Timer Programming On or Direct TV RecordingThe LED blinks when the TV receives a command from the remote control.Remote control signal receiver• Do not place any objects between the TV remote control signal receiver and remote control.