Panasonic WJ-GXE500 Operating Instructions Manual

Also see for WJ-GXE500: Product catalog Integration note Product catalog Installation guide Installation guide

Contents

Panasonic WJ-GXE500 Operating Instructions Manual Manual pdf 23 page image

23Reset the settings/Reboot the unit [Default reset]It is possible to reset the settings or reboot the unit on the [Default reset] tab of the "Maintenance" page on thesetup menu.The settings and the HTML data of the unit can be initialized and reboot of the camera and the unit can be per-formed on this page.[Reset to the default (Except the network settings)]Click the [Execute] button to reset the settings of theunit and RS-485 command table to the default. Notethat the network settings will not be reset.It is impossible to operate the unit for around 2 minutesafter the initialization.Note:• The following network settings will not be reset.On/Off for DHCP, IP address, subnet mask, defaultgateway, HTTP port, line speed, bandwidth control(bit rate), time & date[Load the default HTML files (setup menu).]Click the [Execute] button to reset the settings of theunit, RS-485 command table and HTML file to thedefault. Note that the network settings will not be reset.It is impossible to operate the unit for around 2 minutesafter the initialization.[Reset to the default and load the default HTMLfiles.]Click the [Execute] button to reset the settings of theunit, RS-485 command table and HTML file to thedefault. Note that the network settings will not be reset.It is impossible to operate the unit for around 5 minutesafter the initialization.Note:• The following network settings will not be reset.On/Off for DHCP, IP address, subnet mask, defaultgateway, HTTP port, line speed, bandwidth control(bit rate), time & date[Camera restart]Click the [Execute] button to restart all the camerasconnected to the unit. After restart, it is impossible tocontrol the camera around 1 minute.[Unit restart]Click the [Execute] button to reboot the unit.The unit will be inoperable for around 2 minutes afterthe restart just as when the power is turned on.Note:• To initialize the network settings (☞ page 54), turnoff the power of the unit, then turn on the poweragain while holding down the [INITIAL SET] buttonon the unit for 5 seconds. Wait around 2 minutesafter releasing the button. The unit will start up andthe settings including the network settings will beinitialized.Do not turn off the power of the unit until the initial-ization is complete and the SDHC/SD memory carderror LED lights up.• The notification function allows users to provide thenotification of the error to the specified mail addressand an original alarm destination when an error suchas no SD memory card insertion after the reboot ora locked SD memory card insertion occurs. (☞ Page48)