Panasonic WJ-GXE500 Operating Instructions Manual

Also see for WJ-GXE500: Product catalog Integration note Product catalog Installation guide Installation guide

Contents

Panasonic WJ-GXE500 Operating Instructions Manual Manual pdf 48 page image

48[Notification] tabRefer to page 28 for general information about this tab.Setup items Setting values(Underlined: default)Mail notification Mail notification On/OffDestination of notification Address1 - 4 Alarm *1 On/OffDiag. *2 On/OffDestination address (Default: None (blank))Mail subject (Default: None (blank))Mail body *3 (Default: None (blank))Panasonic alarm protocolnotificationPanasonic alarm protocol *4 On/OffDestination port *5 1 - 65 535 (Default: 1 818)Retry times 0 - 30 (Default: 2)Destination of notification*6Address1 - 3 Alarm *7 On/OffDiag. *8 On/OffDestination IP address (Default: None (blank))Important:*6 • When a device does not exist on the registered IP address, notification may be delayed.*1 • The mail notification will be performed upon an alarm occurrence.*2 • Mail notification will be provided in the following cases.• When it is configured to notify users of available capacity of the SD memory card• When the capacity of the SD memory card has become insufficient• When the SD memory card has failed to mount• When the video loss is recovered*3 • Notification mail will be sent with the following message. (The message to be sent differs depending onthe status of the SD memory card.)• "The SD memory card is full." (This message will be sent when the SD memory card becomes full.)• "The SD memory card cannot be recognized." (This message will be sent when the SD memory cardhas failed to mount.)*4 • When "On" is selected, notification of the alarm occurrence will be provided to the registered destinationaddresses in order (to IP address 1 first, to IP address 3 last).*5 • The following port numbers are unavailable since they are already in use.20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 995, 10 669, 10 670*7 • The Panasonic alarm notification will be provided upon an alarm occurrence.*8 • Maintenance requirement will be notified in the following cases.• When it is configured to notify users of available capacity of the SD memory card• When the capacity of the SD memory card has become insufficient• When the SD memory card has failed to mount• When the video loss is recovered