Panasonic WJ-HD220 Operating Instructions Manual

Also see for WJHD220 - DIGITAL DISK RECORDER: Reference Reference Specifications Brochure & specs Operating instructions

Contents

Panasonic WJ-HD220 Operating Instructions Manual Manual pdf 37 page image

37 Alarm Setup (ALARM SETUP)The digital disk recorder accepts alarm signals suppliedfrom connected devices such as sensors or camera siteequipment. The recorder itself also generates an alarm sig-nal when the preset motion detection is activated. Anyalarm signal starts recording with the preset recordingmode, field rate, and picture quality specified in the RECMODE menu described earlier. Alarm recording stopswhen the preset time has elapsed, the alarm [RESET] but-ton on the front panel is pressed, or the ALARM RESET INsignal is supplied from the connected device. The recorderoutputs an alarm recovery signal from the rear panel. Alarm Buzzer (ALARM BUZZ)Enables or disables buzzer beeping when an alarm oper-ates.1. Move the cursor to ALARM BUZZ with the [D] or [C]button.2. Rotate the JogDial to select ON or OFF.The default is ON.ON: Buzzer beeps while alarm is active.OFF: Buzzer does not beep. Video Loss (VIDEO LOSS)Enables or disables video loss detection.1. Move the cursor to VIDEO LOSS with the [D] or [C]button.2. Rotate the JogDial to select ON or OFF.The default is ON.ON: Enables the recorder to detect video loss.OFF: Ignores video loss. Monitor Mode (MONITOR MODE)This setting specifies whether to allow the display on themultiscreen monitor and spot monitor to change from thecurrently displayed picture to the alarmed channel when analarm operates.1. Move the cursor to MULTI OUT or SPOT OUT with the[D] or [C] button.2. Select the parameter with the JogDial, and press theJogDial.The default is SPOT.SPOT: Switches to the picture of the alarmed channel.OFF: Retains the previous display mode. Video Motion Detection(VMD SETUP)A VMD or Video Motion Detector senses changes in thevideo signals within a preset area and supplies alarm out-put. When a change is detected, the recorder starts record-ing. The detection sensitivity and area are selected on thismenu.1. Move the cursor to VMD SETUPO with the [D] or [C]button, and press the JogDial. The VMD SETUP windowopens.2. Move the cursor to the desired line.3. Rotate the JogDial to select the desired parameter, andpress the JogDial.The default is OFF.LOW: Low sensitivityMID: Medium sensitivityHIGH: High sensitivityOFF: Motion detection is disabled.The area setup window appears with an asterisk whenother than OFF is selected. The asterisk represents theupper-left or bottom-right of the detection area. Thedivision lines are not actually displayed on the monitor.ALARM SETUPALARM BUZZ ONVIDEO LOSS ONMONITOR MODEMULTI OUT SPOTSPOT OUT SPOTVMD SETUPOVMD SETUPCAM SENS1 OFF2 LOWO3 MIDO4 HIGHO5 OFF6 OFF7 OFF8 OFF