Panasonic WJ-HD220 Operating Instructions Manual

Also see for WJHD220 - DIGITAL DISK RECORDER: Reference Reference Specifications Brochure & specs Operating instructions

Contents

Panasonic WJ-HD220 Operating Instructions Manual Manual pdf 47 page image

47 Connected Alarm SensorsA maximum of eight sensors can be connected to the termi-nals on the rear panel. Sensors may be installed in suchplaces as parking lots or reception desks where cars andvisitors come and go. Built-in Motion DetectorThe recorder detects motion for each of the eight videoinputs, based on certain changes in the video signal. Built-in Video Loss DetectorThe recorder detects any disconnection of the video inputs.The images of the disconnected channel will not be record-ed. PC AlarmThe recorder receives an alarm from a PC. Alarm OutputThe following outputs will be performed when TRIGGERACTION SETUP is set to REC&ALM in the REC SETUPmenu. Only recording will be performed when set to REC,and no action will take place when set to OFF. Front Panel IndicatorsWhen an alarm is received, the ALARM indicator blinks andthe LED in the corresponding [CAMERA SELECT] buttonblinks. More LEDs will blink when more alarm inputs arise.The LED will stop blinking when the preset time haselapsed (Auto Reset), when the [RESET] button is pressedon the front panel (Manual Reset), when the external resetsignal is received on the rear panel (External Reset), orwhen the video signal lost on any channel is restored(Video Loss).The ALARM indicator will change from blinking to a steadylight when Auto Reset or External Reset is implemented.This steady light notifies the system operator that therehave been alarm activations that have not yet been manual-ly reset.ALARMSUSPENDRESETCAMERA SELECT152637485. Press any of the numeric buttons to quit the sequenceand return to spot monitoring.Notes:• The Auto Skip function can be programmed in themenu setup to be applied to the sequence to skip anysteps where no video signal is present.• You can individually run a sequence on the spot moni-tor and on the multiscreen monitor. Select a monitorwith the [SPOT/MULTI] button, then press the SEQ but-ton to start or pause a sequence on the respectivemonitor. Viewing a Multiscreen LiveThe multiscreen monitor can display multiscreen liveimages. The available split patterns are: Quad A (input 1, 2,3, 4), Quad B (input 5, 6, 7, 8), and 9-split (input 1-8).1. Press the [MULTI SCREEN SELECT] button repeatedly.The pattern changes every time the button is presseddepending on the setup for MULTI SEQ SETUP.When ALL is selected:Pattern 4A → Pattern 4B → Pattern 9 → Pattern 4AWhen QUAD ONLY is selected:Pattern 4A → Pattern 4B → Pattern 4AAlarm Control FunctionThe recorder performs alarm functions to warn the systemoperators when an event has occurred. Alarm InputThere are four alarm inputs to the recorder that allow therecorder to output warnings.132457681 2 34 5 67 8(4A) (4B)9-split screenMULTISCREENSELECTMULTISCREENSELECTMULTISCREENSELECT13245768(4A) (4B)MULTISCREENSELECTMULTISCREENSELECT