96You can implement any of the following operations as necessary.REMOVE LINK: Logically removes the HDD link.HDD FORMAT: Formats the HDD.RESTART: Closes the menu, and restarts the recorder.The menu can also be displayed manually when you need to format the HDD or remove the logical link.1. Turn off the power of the recorder once, and turn it on again.The multiscreen monitor displays the message "SYSTEM CHECK DONE! TO OPEN DISK MENU, PUSH STOP KEY".2. Press the [STOP] button.The DISK MENU opens.3. Select REMOVE LINK, HDD FORMAT, or RESTART.Auto-removeWhen no button is pressed for one minute after opening the DISK MENU, the recorder will logically remove a disk that meetsany of the conditions below.• An HDD has been categorized as " * ", "LOST", or "ERR".• Restart was repeated 3 times due to writing error. DISK MENU8 Disk MenuThe menu appears if the hard disk error is found duringpower-up.The buzzer beeps every 5 seconds, and the ERRORindicator turns off.Press any button other than [STOP] to mute the buzzerbeep.The hard disk status and required operations are shown in the table.DISK MENUNO.1:XXX.XXGBNO.2:XXX.XXGBREMOVE LINK SET→HDD FORMAT SET→RESTART SET→Hard Disk StatusOperationAbbreviation Status Required–Format, remove link ,or replace HDDif erred even after formatting.NoteWR1 or WR2 appears in SYSTEM LOGwhen indicating a writing error.Normal statusWriting errorSame as above.LOST or * status was left forone minute.All existing HDD have been previouslyused in another WJ-HD220.Restart or FormatAwaiting formatHDD is removed without executingREMOVE LINK command.Remove link, or add a new HDD.HDD physically removedFormatHDD added, and awaitingformatCapacityERR*LOSTADDREMOVE LINK command has beenpreviously carried out.Previous time and this time,HDD physically or logicallyremoved–