Panasonic WJ-HD309A Operating Instructions Manual

Also see for WJHD309A - DIGITAL DISK RECORDER: Reference Reference Manual Operating instructions Conversion guideline

Contents

Panasonic WJ-HD309A Operating Instructions Manual Manual pdf 12 page image

12!1 PS·Data Ports (DATA)Connect PS·Data compatible devices with these ports.!2 Mode Switches (MODE)Set the operation mode of this unit with these dipswitches.!3 RS485 Ports (RS485 (CAMERA))Connect RS485 compatible combination cameras withthese ports.!4 Network Port (10/100BASE-T)Connect this unit to a network compatible with 10BASE-T or 100BASE-Tx when controlling this unit using a PCvia a network.!5 Copy Port (COPY1)Connect a recommended external recording device tothis port.!6 Extra Storage Port (EXT STORAGE)Connect an optional extension unit (WJ-HDE300 series)with this port.!7 Power Switch (POWER)Turns the power of this unit on and off.!8 Signal Ground Terminal (SIGNAL GND)!9 Power Cord Inlet (AC IN)Connect the power cord to this inlet.@0 Cable ClampFix the cables with this cable clamp to prevent discon-nection or unstable connections that may cause record-ing failures or an unstable system. On Monitor 1 (To display onlylive image)The negative circled numbers indicate the default positionsof camera title q, time w and event display e.Important:• The SETUP MENU will be displayed on monitor 2 andthe VGA monitor. (It is impossible to display the SETUPMENU on monitor 1.)• It will take around 2 minutes to display live images onmonitor 1 after turning on the power of the unit.1. Camera TitleDisplays the edited camera title.A position to display the camera title can be selectedfrom the following.Upper left, upper right, lower left, lower right, centerThe default camera title position is upper right (R-UPPER).Note: The camera title will be displayed with 16 charac-ters (2 lines: 8 characters per line).2. TimeDisplays the current time (hour:minute:second) anddate (month:day:year).A position to display the time can be selected from thefollowing.Upper left, lower left, upper right, lower rightThe default time display position is upper left (L-UPPER).Notes:• When the camera title and the time display are lay-ered, only the time display will be displayed.• When monitor 1 is selected, it is possible to turnon/off display of the camera title and the time bypressing the camera selection button 8 for the WJ-HD316A (the camera selection button 6 for the WJ-HD309A) while the shift function is on (by pressingthe SHIFT button).3. Event DisplayWhen an event has occurred, an event display will bedisplayed.The position of an event display will be symmetrical tothe position where the time is displayed. When the timeis displayed at the lower left of the screen, an event dis-play will be displayed at the upper right corner of thescreen. The default position of an event display is theupper right corner of the screen (R-UPPER).The event display will be displayed differently as followsdepending on which event has occurred.VMD-*: When motion is detected.LOSS-*: When video loss has occurred.COM-#: When a command alarm has occurred.TRM-#: When a terminal alarm has occurred.*: Camera number (1 - 16 for the WJ-HD316A, 1 - 9 forthe WJ-HD309A)#: Alarm numberNote: Refer to page 49 for further information aboutevent types and event actions.qq qqqwewewewe