75Configure the event action at a VMD occurrence [VMD]Select the [VMD] tab on the "Event" page. (☞ Page 60)The settings relating to event actions to be taken at a VMD (☞ Operating Instructions (PDF)) occurrence can be configured onthis tab.[Operation Mode]Select the settings for the operation mode. Refer to theoperating instructions (PDF) for further information about theoperation mode.ADM (Activity Detection Mode): Performs onlyrecording and writing an event log at an event occur-rence. Other event actions will not be performed.ALM (Alarm Mode): Performs every event actionaccording to the settings.Off: Performs only writing an event log. Other eventactions will not be performed.Default: ALMConfigure the following settings for each camera channel (1to 16).[Rec. cam.]Select a camera channel (1 to 16) used for recording. When"Off" is selected, recording will not be performed.[Preset]Select a preset position (1 to 256) to which the camera willmove at a VMD detection.When the preset positions of two or more cameras havebeen selected on the advanced setup page, "∗∗∗" is dis-played and it is impossible to select the values.[Output terminal]Select a terminal (TRM1 to TRM16) to output the alarm sig-nal.[Search]Select "On" or "Off" to determine whether or not to performvideo motion detection.When "Off" is selected, video motion detection will not beperformed. When "On" is selected, VMD (video motiondetection) areas can be set.Up to 4 areas can be set for a camera channel for the detec-tion area. Details on video motion detection are given onOperating Instructions (PDF).[Area] buttonConfigure the settings for each camera channel (1 to 16).(☞ Page 77)• [REC]Select a camera channel (1 to 16) used for recording.When "Off" is selected, recording will not be performed.The selected setting will be applied to the setting for"Rec. cam." on the [Video loss] tab (☞ page 74).• [Preset]Select a preset position (1 to 256) to which the camerawill move at a video loss occurrence.The selected setting will be applied to the setting for"Preset" on the [Video loss] tab (☞ page 74).• [Back] buttonCloses the advanced setup page and returns to the[Video loss] tab (☞ page 74).
