99Configure the settings relating to network [Network]The basic network settings required to operate this unit using a PC via a network such as a LAN can be configured on the"Network" page. The settings relating to the Panasonic alarm protocol and the settings relating to the resolution and rate totransmit live images can also be configured on this page.The "Network" page has [Basic], [DNS], [DDNS], [SNMP], [Panasonic alarm protocol] and [Transmission] tabs.Configure the basic settings relating to a network [Basic]Select the [Basic] tab on the "Network" page. (☞ Page 60)The basic settings relating to a network can be configured on this tab.[HTTP port number]Specify the HTTP port number to be used to send imagesfrom the unit.It is unnecessary to change it for normal use.1 - 65535Default: 80Note:• Depending on the network settings, network communi-cation may not be established if the http port numberhas been changed. In this case, refer to the administra-tor of the network.• The following numbers and the FTP port number areunavailable for the HTTP port number.20, 21, 23, 25, 42, 53, 67, 68, 69, 79, 105, 110, 123,161, 162, 546, 547, 995, 10001, 10002, 10003, 10004,10005, 10006, 10007[FTP port number]Designate the FTP port number of the recorder.It is unnecessary to change it for normal use.1 - 65535Default: 21Note:• The following numbers and the HTTP port number areunavailable for the FTP port number.20, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110, 123,161, 162, 546, 547, 995, 10001, 10002, 10003, 10004,10005, 10006, 10007■ Network portThe setting for the network port on the rear panel of therecorder is configured.This setting is required to operate the recorder from a PCconnected via a network using the network ports.[DHCP]Select "On" or "Off" to determine whether or not to use theDHCP server.Select "On" to obtain an IP address, a subnet mask and agateway address from the DHCP server.Set to "Off" when entering the addresses above manually.The IP address, subnet mask and default gateway obtainedfrom the DHCP server are displayed on each setting area.Default: OffNote:• When the setting of DHCP is changed from "On" to"Off", the setting of DNS will be automatically changedto from "Auto" to "Off".
