If operator ID and password are correct, "OK" willappear for 2 seconds on the LCD display.Note: If an operator ID and password error haveoccurred, "NG" will appear for 2 seconds on theLCD display with a beep sound, then the Log-inprocedure automatically returns to the start. Log-outThis function is used when an operator is leaving the con-troller, or no longer requires access to the system.1. Hold down the [LOGOUT] key and then press the[CAMERA (ENTER)] key to log out."NO OPERATOR" is displayed on the LCD display ofthe controller.2. Turn off the Power switch located on the rear of thecontroller.Before starting the following procedures, all system compo-nents must be turned on.The following procedures apply when the WV-CU850System Controller is connected to the system. Some offunctions are not available when the WV-CU360C SystemController is connected. Log-in1. Turn on the power switches of all system components.2. Press the POWER ON/OFF Switch located on the rearof the System Controller, to the ON position.The LINK indicator lights up and the following displayswill appear on the LCD display of the system controller.3. Select your registered operator ID number (up to 5 dig-its) by pressing the numeric keys, then press the[CAMERA (ENTER)] key."PASSWORD" will appear on the LCD display of thecontroller.4. Select your registered password (up to 5 digits) bypressing the numeric keys, then press the [CAMERA(ENTER)] key.28INFORMATIONHELLO!INFORMATIONID:NO OPERATORINFORMATIONID:100INFORMATIONID:100PASSWORD:–––––LOGOUTAUX1 OFF AUX1 ONCALLPRESETPGMPRESETC A MP O S ID I G I TA LO U TDEF OFF DEF ONAREAAUX2 OFF AUX2 ONCAMERA(ENTER)AUTO PANCAM IDVLD ST&DALM S GENSYS S(ALARM)087MSTATUSVLD HALLALM HBLK59642 31SHIFTCLEAR(ESC)EXITINFORMATIONID:100PASSWORD:**INFORMATIONID:100PASSWORD:OK*****LOGOUTAUX1 OFF AUX1 ONCALLPRESETPGMPRESETC A MP O S ID I G I TA LO U TDEF OFF DEF ONAREAAUX2 OFF AUX2 ONCAMERA(ENTER)AUTO PANCAM IDVLD ST&DALM S GENSYS S(ALARM)087MSTATUSVLD HALLALM HBLK59642 31SHIFTCLEAR(ESC)EXITLog-in and Log-outINFORMATIONID:NO OPERATORLOGOUTAUX1 OFF AUX1 ONCALLPRESETPGMPRESETC A MP O S ID I G I TA LO U TDEF OFF DEF ONAREAAUX2 OFF AUX2 ONCAMERA(ENTER)AUTO PANCAM IDVLD ST&DALM S GENSYS S(ALARM)087MSTATUSVLD HALLALM HBLK59642 31SHIFTCLEAR(ESC)EXIT