Panasonic WJ-SX650 Operating Instructions Manual

Also see for WJHD309 - DIGITAL DISK RECORDER: Manual Operating instructions Operating instructions Operating instructions Specifications

Contents

Panasonic WJ-SX650 Operating Instructions Manual Manual pdf 13 page image

13■ Monitor Display InformationThe following are the details on terminal mode operations. For PS·Data operations, refer to p. 48 OPERATION (OTHER THANTHE TERMINAL MODE) or the operating instructions of system controllers.q Time and Date InformationCurrent time and date are displayed.During daylight saving time (summer time), "∗" is dis-played beside the time.Example: Aug/02/2005 ∗20:15:56Note: While a recorder is being selected, time and dateare not displayed.w Monitor Status InformationMonitor numberM01 to 32: Monitor numberNote: During monitor lock, monitor number is highlight-ed.Controller numberDisplays a device that selects and controls the monitor.K1-1 to 8-4: Terminal mode system controller(Example: For K8-4, "8" means the terminal (TMNL)number and "4" means the controller number of sys-tem controller.)PSD: PS·Data mode system controllerPC: PC connected to the SERIAL port/T001 to 128: Timer eventSequence numberDisplays the active sequence number.T01 to 32: Tour sequence numberG01 to 32: Group sequence numberNote: During sequence pause, "P" is displayed besidethe sequence number.e Camera InformationCamera numberC001 to 999: Camera numberR01 to 16: Recorder numberCamera titleDisplays the registered camera title.Camera title setting is performed in "Camera" – "CameraTitle" of WJ-SX650 Series Administrator Console.r Event InformationTERMINAL001 to 256: Terminal alarm has occurred.(Example: For TERMINAL001, "001" means thenumber of alarm input signal accepted by theALARM IN port of video input board.)CAMERA001 to 099: Camera alarm has occurred.(Example: For CAMERA001, "001" means the num-ber of camera supplying an alarm input signal tothe unit.)RECORDER001 to 999: Recorder alarm has occurred.(Example: For RECORDER001, "001" means thenumber of camera associated with the recordersupplying an alarm input signal to the unit.)SERIAL0001 to 1024: Serial alarm has occurred.(Example: For SERIAL0001, "0001" means the serialcommand alarm input number.)VIDEO LOSS001 to 999: Video loss has occurred.(Example: For VIDEO LOSS001, "001" means the num-ber of camera to which video loss has occurred)SUSPEND: Alarm is suspended.rqwe!3 VS Output Connector (VS OUT)Supplies VS output signals to external devices. While !1is accepting a VS input signal, !3 supplies an outputsignal synchronizing the VS input signal. While !1 is notaccepting the VS input signal, !3 supplies an internalsynchronization output signal.!4 Serial Port (SERIAL)Connects to a PC.Note: When q is set as Video Output Board 2, r, !1,!2, !3, and !4 are not available.