Panasonic WJ-SX650 Operating Instructions Manual

Also see for WJHD309 - DIGITAL DISK RECORDER: Manual Operating instructions Operating instructions Operating instructions Specifications

Contents

Panasonic WJ-SX650 Operating Instructions Manual Manual pdf 38 page image

38Before operation, setup of this unit is required. Setup is per-formed from WJ-SX650 Series Administrator Consoleinstalled on a PC. (Some settings are available from SETUPMENU of this unit.) The following is an example of setupprocedure.Notes:• Setup may differ depending on system composition.(Settings of Step 1 and 4 in the following proceduremust be performed.)• For Step 2, 3, 5 and 6 in the following setup procedure,the factory default can be maintained.Example: camera x 150, recorder x 10, monitor x 32, andsystem controller x 2 (Terminal mode)1. Perform the recorder settings.Recorder Out: Input Board No.5 (When video input sig-nals are supplied from recorders to CAM160 to 151)Recorder 1 to 10: ONRecorder 11 to 16: OFFNote: Check if recorders are properly connected to theDATA port and CAM (camera input channels) currentlydisplayed.

"System" – "Recorder"RECORDER (Refer to p. 87.)2. Perform the DATA port settings. (In this example, main-tain the factory default.)DATA 1, 2, 5 and 6 ports: TMNLDATA 3, 4, 7 and 8 ports: HDRNote: Change these parameters when using PS·Datasystem controllers, etc.

"System" – "DATA Port"DATA PORT (Refer to p. 90.)

"System" – "VD2/DATA/Cable Comp."VD2/DATA/CABLE COMPENSATION (Refer to p. 91.)3. Perform the LCN (Logical Camera Number) settings.CAM001 to 160: If you change LCN settings, selectdesired parameters.CAM161 to 256: Delete the LCN parameters.Notes:• Set LCN parameters for CAM151 to 160 surely, eventhough these channels accept video input signals fromrecorders. Without LCN settings, recorder selection isunavailable.• By deleting the LCN parameters of unused camerachannels, operators can select only existing cameranumbers.

"System" – "Logical Camera Number"Not available4. Perform the camera settings.CAM001 to 150: Select desired parameters for thesecameras. (To use cameras of other manufacturers,set DATA to OFF.) For Cable (cable compensation),select the parameter suited to the cable length.CAM151 to 160: Set DATA to OFF. (Video input signalsare supplied from recorders to these channels.)SETUP PROCEDURE