Panasonic WJ-SX650 Operating Instructions Manual

Also see for WJHD309 - DIGITAL DISK RECORDER: Manual Operating instructions Operating instructions Operating instructions Specifications

Contents

Panasonic WJ-SX650 Operating Instructions Manual Manual pdf 56 page image

56■ Operation End (Logout)You need to log out of the system:• When finishing operations and powering off• When changing an operator● WV-CU950/650During the login status, press the LOGOUT button whileholding down the SHIFT button.The LCD returns to the login standby display.● WV-CU360C/CJDuring the login status, press the LOG OUT button whileholding down the SHIFT button.The LCD returns to the login standby display.■ Operation Start/End (AutoLogin/Logout)• To activate auto login or auto logout, the setting isrequired in advance.• The auto login and auto logout settings is performed in"Controller" – "Auto Login/Logout" of WJ-SX650 SeriesAdministrator Console.• Auto login and auto logout are set for each DATA port.Operators logging into the system from the same DATAport have the common setting.• When both auto login and auto logout are set for aDATA port, system controllers connected to the portperform login and logout automatically. Then, the sys-tem controller returns to the status before monitor selec-tion.■ Power-on/off1. To power on the unit, press the power switch behindthe front panel.2. Power on system controllers and recorders. (Refer tothe operating instructions of each system device forhow to power on.)3. When finishing operations, power off each device in thesame procedure as power on.■ Operation Start (Login)By logging into the system as a registered operator, youcan control system devices with the authority of that opera-tor.1. Turn on the power. (Refer to Power-on/off.)2. Wait until the login standby display appears.

Note: If the password is wrong or no operation has beenperformed for 5 seconds or more, the LCD display willreturn to the login standby display.3. Enter the user ID by pressing numeric buttons, andpress the CAM (SET) button.4. Enter the password by pressing numeric buttons, andpress the CAM (SET) button.

The system controller will enter the login status, and theLCD display will become the default status.Ｍｏｎ - - Ｃａｍ - - -