6300-A2-GB20-10 November 2003 E-1EFirmware UpgradeOverviewThe Hotwire 6351 ReachDSL Router supports a TFTP client for the purpose offirmware upgrades within the service domain. The Network Service Provider(NSP) can initiate upgrades for the ReachDSL Router using CLI commands fromthe local console or through Telnet access.Firmware Upgrade Commandsdownload {dsl1[:ifn] | eth1[:ifn]} server-ip filenameMinimum Access Level: AdministratorCommand Mode: ConfigPerforms a firmware download for the specified interface, TFTP server IP address, andfirmware image filename.dsl1 [:ifn] – The DSL interface for the TFTP session.NOTE: The interface must be configured, or the command will be rejected. If an IPaddress is configured for the interface, the TFTP client will assume the configuredaddress. If the DSL interface is unnumbered, the TFTP client will assume the IPaddress of the Ethernet interface, if one is configured.eth1 [:ifn] – The Ethernet interface for the TFTP session.NOTE: The interface must be configured, or the command will be rejected. If an IPaddress is configured for the interface, the TFTP client will assume the configuredaddress.server-ip – The TFTP server host IP address.NOTE: The server must be accessible within the service domain and a route must existfor the TFTP session to become active.filename – The firmware image file name, 1–31 characters.NOTE: The filename must match the filename as it exists on the TFTP server.apply downloadMinimum Access Level: AdministratorCommand Mode: ConfigProvides the capability of activating an alternate firmware image. This command istypically used following a successful download of a new firmware image.
