4. DSL Router Configuration Examples4-2 November 2003 6300-A2-GB20-10NOTES:— Configuration examples included in this chapter cover some commonconfigurations, providing only a few of the possible scenarios.— IP addresses used in the examples are for illustrative purposes only; theyare not intended to be used when configuring your local network.— Adding static routes to the core router is typically necessary when routingis enabled.— Bridging-only mode is the default configuration.Basic Bridging Configuration ExampleThis is the factory default configuration. To return the DSL router to the factorydefault configuration, use the following command: configure factory.NOTES:— When the DSL router is configured for bridging, DSL link encapsulation forthe DSL port must be configured for EtherHDLC at the line card.— This configuration is only supported with firmware version 4.2.5 or higher.01-16966Customer Premises (CP)DSLRouterHub155.1.3.2155.1.3.3155.1.3.4IP, IPX,Apple Talk, etc.,End-userSystemsConsolePortConnectionEthernetDSLCoreRouterWAN155.1.3.1155.1.3.5
