Parker compax3s Installation Manual

Also see for Compax3S: Installation manual Operating instructions Quick reference guide Installation manual

Parker EME Compax3 device description192-120102 N16 December 2010 233.3.4. Motor / Motor brake (C3S connector X3)PIN Designation Motor cable lead designation*1 U (motor) U / L1 / C / L+ 1 U12 V (motor) V / L2 2 V23 W (motor) W / L3 / D / L- 3 W34 PE (motor) YE / GN YE / GN YE / GN5 BR+ Motor holding brake WH 4 Br16 BR- Motor holding brake BK 5 Br2* depending on the cable typeRequirements for motor cable< 100m (the cable should not be rolled up!)A motor output filter is required for motor cables >20 m:Shielding connection of the motor cableThe cable must be fully-screened and connected to the Compax3 housing. Use thecable clamps/shield connecting terminals furnished with the device.The shield of the cable must also be connected with the motor housing. The fixing(via plug or screw in the terminal box) depends on the motor type.Attention - Please wire the motor holding brake!Connect the brake only on motors which have a holding brake! Otherwise make nobrake connections at all.Requirements cables for motor holding brakeIf a motor holding brake is present, one cable of the motor holding brake must befed on the device side through the toroidal core ferrite provided as accessoryZBH0x/xx (63Ω @1MHz, di=5.1mm), in order to ensure error-free switching onand off of the motor holding brake.Motor holding brake outputMotor holding brake output Compax3Voltage range 21 – 27VDCMaximum output current (short circuitproof) 1.6AMotor cable