Philips 40PFL4911 User Manual

Also see for 4000 series: Quick start guide User manual Quick start guide Service manual Quick start guide

These Operations are accessible by Remote Control.Some may also be accessible by the Main Unit's Control Panel.Initial SetupThis section will guide you through the Unit’s Initial setting which includesselecting a Language for your On-screen Menu, country, location andAutoprogram, which Automatically scans and memorizes viewablechannels. You can also set the network connection in this setting.BBefore you begin:Make sure the Unit is connected to an Antenna or Cable.1 After making All the Necessary Connections, press to Turn On theUnit.• It may take a few moments to Turn On the Unit for the first time.• Initial setup menu appears Automatically after the Unit is TurnedOn.2 Use to Select the on-screen language, country, TV placementand location in the middle of the TV screen, then press OK.• You must set Home in location setting. Otherwise, Picture andSound settings you adjusted will not be memorized after the Unitgoes into Standby mode.3 Use to Select Skip or Next on Network setup screen.4 Use to Select Wireless or Wired, then press OK.1 234 756SkipWiredWirelessThis TV can be connected toyour home network. Select yourconnection type.InstallationWireless If you have a Wireless Router, select Wireless toconnect to the Internet.Wired If you connect with an Ethernet Cable, select Wiredto connect to the Internet.• If you have a router with easy connect function, select Wireless anduse to Select Easy Connect, then press OK.5 Follow the on-screen instructions to complete the installation.• When you select On in the selection screen for Auto softwareupdate, A message will appear later if there is the latest softwareon the network server.6 Use to Select the signal type.• If the TV is connected to a Cable or Satellite Set-top Box, select the2nd one and skip to step 8.1 234 756InstallationSet-top boxSelect "Set-top box" to set up a TVsignal from a cable TV boxor satellite TV receiver.AntennaSelect "Antenna" to set up a TVsignal from a cable TV wall jackor a standard TV antenna.7 Use to Select Antenna for TV channels or Cable for CATVchannels, then press OK.1 234 756InstallationSkipCableAntennaNow select either Antenna orCable, using up/down key of theremote control. Once you havemade your selection, press theOK button to proceed.Make sure that you haveattached your antenna or cablesignal into the jack on the back ofyour TV labeled "ANTENNA IN".–When Antenna is selected, the TV detects Antenna signals. Itsearches for DTV and Analog TV channels available in your area.–When Cable is selected, the TV detects signals supplied by cable.It searches for DTV, Analog TV and Cable channels available inyour area.• Auto programming will begin.001 234 756InstallationStopTotal progress:Analog channels found:Digital channels found:Please wait until you see the AutoProgramming complete message.Digital channels will take longerthan Analog to find and program.Auto programming may take morethan 20 minutes to complete.System searching. Please wait…16 .EnglishContinued on next page.