Philips 40PFL4911 User Manual

Also see for 4000 series: Quick start guide User manual Quick start guide Service manual Quick start guide

Network settings1 Press and use to Select Setup, then press OK.2 Use to Select Network settings, then press OK.3 Adjust the following items.Manual network settings1 Use to Select Manual network settings, then press OK.Proxy configurationIP configurationWireless network settingNetwork selectionReset network settingsNet TVWake-on-LAN(DIAL)Home networkSetting statusConnection testManual network settingsNetwork selection2 Use to Select Network selection, then press OK.3 Use to Select the desired setting, then press OK.Wired If you connect to an Ethernet Cable, select Wiredto connect to the Internet.Wireless If you have a router with easy connect function,select Wireless to connect to the Internet.Wireless network settingThis menu is displayed only when you set Wireless in Network selection.In order to use a wireless network, you must set up a connection to theAP (e.g. Wireless Router).2 Use to Select Wireless network setting, then press OK.AutoSearch for wireless networks automatically and select the SSID from thelist.3 Use to Select Auto, then press OK.4 The list of wireless networks will be displayed. Use to Select theappropriate the SSID, then press OK.Manually enter your SSIDAutoRouter 4Router 3Router 2Router 1ManualEasy ConnectPin code• If you select the SSID with , WEP*2 / others Key entry screen willappear. Enter the WEP*2 / others key of the selected wirelessnetwork using , then press OK.• If you select the SSID has an easy connect, the easy connect settingscreen will appear. Use to Select a setting, then press OK.Easy ConnectSelect this Setting if your Router has an easyconnect button. Start Scanning for wirelessnetworks on the TV after pressing the easyconnect button on your Router. If Connection Testfails, try Easy Connect again.*1 If it fails then referto the Router’s Manual for more details.Pin codeSelect this Setting if your Router has an easyconnect feature but does not have an easyconnect button. Enter the 8-digit PIN code shownon your TV in the Router settings menu via PCbefore Connect is selected.ManualIf your wireless network with authentication setting(WEP*2, others), WEP*2 / others Key entry screenwill appear. Enter the WEP*2 / others key of theselected wireless network using , thenpress OK.*1 Easy Connect cannot be used when the security protocol is set toWEP. Change the Access Point’s security mode from WEP to others(recommended).*2 WEP is not recommended to be used due to its Major security flaws.Change the Security protocol on the Wireless Router to others(recommended) mode.Confirmation message will appear. Select OK to complete the settings.Note(s)• For a wireless network with authentication setting, key icon appears to the right hand of theSSID.• Signal icon shows the strength of the signal.• WEP*2 / others key appears as asterisks on the confirmation screen.• The wireless LAN supports following specifications.–Wireless standards: IEEE 802.1 1 b/g/n–Frequency spectrum: 2.4GHz–Security protocol: WEP*2 / others38 .EnglishContinued on next page.