Q-See QSDR04RTC User Manual

Also see for QSDR04RTC: Quick installation guide

User Manual115.2.3.2 PPPoE.5.2.3.3 StaticWhen selecting static allocation, You will need to setup the network settings on the DVR to match thesettings of the router that you attach the DVR to. To get the router settings you would go to the Run option ona computer attached to the same router as the DVR and type cmd and hit OK to bring up a command prompt(Picture 5-9), then type ipconfig at the prompt (RED arrow on Picture 5-9) to access the router settings. Writedown the gateway and subnet mask numbers (GREEN arrows on (Picture 5-9) so you can copy them into thenetwork settings on the DVR (Picture 5-10). To get to the NETWORK SETUP window, Go to [MainMenuNetwork Set] then use the Direction Keys on the DVR to go to the TYPE dropdown and selectSTATICFor the DVRs IP address you would enter the same first 3 sets of numbers as the gateway and select afourth set of numbers that is different then any other device attached to the same router. If the IP address ofyour computer in the ipconfig (BLUE arrow in Pic 5) was a single or two digit number you should be ok withany three digit number, if the computer IP address ends with a number in the 100s then you should go with a200 number (LIGHT BLUE box in Pic 6). After you enter the addresses hit the OK button.At the bottom of the NETWORK SETUP window there is an option to setup the DVR to be accessedthrough a DDNS service. When you click on the DDNS button it brings up the window displayed as Picture5-11.You can access the DVR through a static or dynamic IP address; however a dynamic address canYour dynamic domain name into an Internet Explorer browser instead of an IP address and be directed towhatever the current dynamic IP address is, so that you can always access the DVR by entering the sameaddress. This DVR also supports the DDNS service provided by dyndns. You can get more information onhow to use these services from the myq-see.com or www.dyndns.com website.When selecting PPPoE, you need to input user andpassword provided by your internet service provider and set upweb port (for details refer to the below picture 5-8)change from time to time. How often depends on your service providerWhen it changes you need to go to a website such aswww.myipaddress.com from a computer attached to the same routeras the DVR to find out what the new IP address is. There are twosolutions to this problem. One would be to get a static IP address fromyour service provider so that you do not have to be concerned with theaddress changing. Another solution would to use a dynamic domainname service to get a domain name that can be linked to your dynamicaddress. You can register on our company’s myq-see.com website andget a domain name, user name, and password. You can then enterPicture 5-8Picture 5-9 Picture 5-10