QUORION QMP 3000 User Manual

Contents

QUORION QMP 3000 User Manual Manual pdf 35 page image

357.2 Easy ProgrammingThe register has a special program mode which can used by a clerk with Managerauthority or when the Central Lock is in the MANAGER ( M ) position. The mode is startedby entering the mode number on the SUBTOTAL key. When the mode is not activeERROR#1 (Invalid Entry) is shown otherwise the register will print the mode on the receipt,journal and electronic journal.When the register is in Easy Programming Mode you can only exit this mode by eitherturning the Central Lock, remove the Clerk Key or by pressing the SUBTOTAL key withoutentry.In mode 1, 2, 3 or 4 you must:1 - Enter the new data2 - Press SUBTOTAL3 - Press a direct PLU key or enter the number on the PLU# key.4 - Continue with next entry or exit by pressing SUBTOTAL without entry.MODE 1In this mode you can program the Plu Prices. The price of the active level is programmed.When you want the program a price of another level (when active) you must select thelevel first.MODE 2In this mode you can program the Plu Cost Prices.MODE 3In this mode you can program the first Plu Descriptor.MODE 4In this mode you can program the second Plu Descriptor.MODE 5In this mode you can program the Plu Department Selection.MODE 6In this mode you can add inventory to the PLU Inventory total when active.MODE 7In this mode you can subtract inventory from the PLU Inventory total when active.MODE 8In this mode you can change the Minimum PLU Inventory Level when active.MODE 100, 101, 102 and 103These modes are used for PLU file maintenance when Scanning Codes are used.7.3 Programming FilesProgramming the individual files using the keyboard is done by using the UP, DOWN,PGUP, PGDN, TYPE (program type), X and CR (User Report) key.You can only program when the Central Lock is in X, Z or T position. You startprogramming by either entering the FILE# directly on the TYPE key or by pressing theTYPE key without entry which will open the programming window and you can select thefile you want to program. Files which are not active in the configuration of the applicationwill not be shown. At the end of the line the File# number is also shown for reference.