QUORION QMP 3000 User Manual

Contents

QUORION QMP 3000 User Manual Manual pdf 41 page image

41Example 2:External EPSON TM-88 printer of REGISTER# 1 port# 2 as a network KP1 printer.PARAMETER 21 value 3 which means EPSON TM-88PARAMETER 22 as 12 which means register#1 and port# 2.Note that you must program these values in all registers which use this printer.Note: When using a slip printer as shared network printer the register checks the paperwhen the transaction is closed. This means that it will always print on the slip when theoption print on slip is activated even when compulsory slip is not set.7.5.6 Network ReportsIt is possible to set OPTION 1-8 in a USER REPORT which will automatically make thisreport a NETWORK report. Note that also the NETWORK SIZE (PARAMETER 55) mustbe programmed. Whenever a USER report is taken with this option set the register willcheck if all registers are online and take a consolidated report. When not all register areonline the register will give an error an not take the report. You must first switch on theregister or disable it with program mode 99.It is also possible to take a USER REPORT as network report without setting OPTION 1-8.When you add 1000 to the report number the register will also take the USER report as anetwork report.It is also possible to take a SYSTEM REPORT as network report When you add 10000000to the system report code the register will also take the SYSTEM REPORT as a networkreport.7.5.7 Program Mode 99With program mode 99 it is possible to disable or enable a register in the network. In orderto avoid the loss of data the registers in the network will try to sent print, balance andarticle data for ever when an error occurs until you disable the register using MODE 99.When you enable or disable a register in the network using mode 99 the register willtransmit the information to all active registers in the network when NETWORK SIZE is setelse it will only disable the register. You enter the mode by entering 99 on the TYPE keyand the register will show the status of the registers in the network. When network size isnot set the status of 24 (maximum) registers will be shown. By pressing the ENTER (CR)key you can toggle the status of the register.Note: When you are enabling a register take care that is enabled in all connected registersbecause the register will not transmit the information to registers which are disabled.