4 – InstallationiSR6142 Router Installation4-10 SN0051102-00 ASConfigure the RouterYou can configure the router using the SANsurfer Router Manager application orthe command line interface (CLI).The SANsurfer Router Manager provides a Configuration Wizard you can use toconfigure the GE ports. If either of the router’s GE ports have not been configured(IP address is 0.0.0.0), the Configuration Wizard starts automatically when theSANsurfer Router Manager first connects with the router. The system uses theinformation collected in Table 4-2.To configure the router using the command line interface:1. Open a command window according to the type of workstation andconnection: Ethernet (all platforms) – Open a telnet session with the default routerIP address and log in to the router with the default account name andpassword (guest/password).telnet 10.0.0.1username – guestpassword – ******** Serial – On Windows, open the HyperTerminal application. The nextfew steps may vary according to the version of Windows you use.a. From the Windows Start menu, selectPrograms>Accessories>HyperTerminal>HyperTerminal.b. Select the connection you created earlier and click OK. Serial – On Linux, open a command window and enter the followingcommand:minicom2. Open an Admin session and enter the commands to set up both iSCSI portsand the management interface. See the iSR6142 Router CLI User's Guidefor command descriptions.QRouter #> admin startPassword – ******QRouter (admin) #> set mgmt………………………QRouter (admin) #> set iscsi 1………………………QRouter (admin) #> set iscsi 2………………………
