A – Log MessagesInformational Log MessagesSN0051102-00 A A-5AFibre Channel DriverThe following informational log messages are common to both Fibre Channelports: 1 (FC1) and 2 (FC2). The messages are listed in Table A-3 and describedfollowing the table. Log messages beginning with #0 denote Fibre Channel port 1(FC1). Log messages beginning with #1 denote Fibre Channel port 2 (FC2).Table A-3. Fibre Channel Driver—Informational Log MessagesID Log Message No.118882 #%d: QLIoctlDisable: Reset adapter 98119088 #%d: QLIsrEventHandler: LIP occurred (%x): mailbox1 = %x 304119089 #%d: QLIsrEventHandler: LIP reset occurred (%x): mailbox1= %x305119090 #%d: QLIsrEventHandler: Link up (%x) mailbox1 = %x 306119092 #%d: QLIsrEventHandler: Link mode up (%x): RunTimeMode=%x 308119093 #%d: QLIsrEventHandler: RSCN update (%x) rscnInfo: %x 309119097 #%d: QLIsrEventHandler: Port update (%x) mb1-3 %x %x %x 313119552 #%d: QLFcipIsrEventHandler: Link up (%x) mailbox1 = %x 768119553 #%d: QLFcipIsrEventHandler: Link down (%x) 769119554 #%d: QLFcipIsrEventHandler: Link mode up (%x) 77098 Request to reset the FC processor (adapter) received from IOCTL interface.304 Fibre Channel loop initialization procedure (LIP) occurred. The LIP type isreported, as is the contents of the FC processor’s mailbox 1 register.305 Fibre Channel LIP reset occurred. The LIP reset type is reported, as is thecontents of the FC processor’s mailbox 1 register.306 Fibre Channel link up occurred. Event status is reported, as is the contentsof the FC processor’s mailbox 1 register.308 Fibre Channel link up occurred. Event status is reported, as is theRunTimeMode (0 = loop, 1 = point-to-point).309 A RSCN was received. Event status is reported, as is the RSCN information.313 Fibre Channel port update. Event status is reported, as is the contents of theFC processor’s mailbox 1, 2, and 3 registers.