4 – Using the WizardsFCIP Route Add Wizard4-46 SN0054660-00 ASThe FC and GigE Port Selection dialog box prompts you to select anFC-GigE port pair, as shown in Figure 4-55.Figure 4-55 FCIP Route Add Wizard—Port Selection Dialog Box2. Select the FC-GigE Port pair. The corresponding parameter options becomeavailable.3. If desired, configure the following port route/parameters: FCIP Interfaces FC & GE – Provides a drop-down box you can use toenable or disable the FCIP route. Disabling the route places the FCand GE ports in a down state. It still retains all route configurationparameters. GigE Port Programmed Link Rate – Provides a drop-down box youcan use select one of four options for the GigE link rate: Auto, 10, 100,or 1000. The default link rate is Auto. Link Rate Mode – Provides a drop-down box you can use select oneof three options for the link rate mode: Auto, Half Duplex, or FullDuplex. This dialog box is available only when the GigE link rate is setto something other than Auto. GigE Port Flow Control – Provides a drop-down box you can use toenable or disable GigE port flow control. The default is enabled. Thisdialog box is available only when the GigE link rate is set to somethingother than Auto.4. After selecting a port pair and setting GE port parameters, click Next tocontinue or click Cancel to quit the wizard.
