5 – Configuring CHAPNormal Session—Uni-directional CHAP5-4 SN0054660-00 AS6. Check to see if the initiator exists on the discovered iSCSI initiators list: If the initiator is not part of the discovered iSCSI initiators list, then goto the wizard menu and select Add Initiator Wizard. If the initiator is part of the discovered list, then go to Step 10.7. Fill in the IQN name string.8. Select Enable Chap.9. Create a CHAP secret (for example, secret_initiator).10. Go to the MS Initiator and perform the following steps:a. Click General.b. Click Secret (in the middle of the screen).c. If this is the first time you are setting secrets, reset all the secrets.d. Type the secret (secret_target) that you created in Step 5.11. Click Targets.12. Select the target you want to login to.13. Click Log On.14. Click Advanced.15. Select Chap Login Information.16. Type the secret (secret_initiator) that you created in Step 9 into TargetSecret.17. Select Mutual Authentication.18. Click OK.19. Click OK. The initiator completes normal login.Normal Session—Uni-directional CHAPTo program single-direction CHAP during a normal session:1. Do not enable CHAP on the iSCSI presented target.2. Check to see if the initiator exists on the discovered iSCSI initiators list: If the initiator is not part of the discovered iSCSI initiators list, then goto the wizard menu and select Add Initiator Wizard. If the initiator is part of the discovered list, then go too Step 6.3. Fill in the IQN name string.4. Select Enable Chap.
