Figure 4-14 Install the FCO serial communications bridge cable (bottom view of the FCO)13. Prepare to insert the appropriate SFP (Small Form Factor Pluggable) trans-ceiver into the FCO. Note that the SFP adapter is keyed and the small circuitboard connector is facing you when oriented correctly. See Figure 4-15. Locatethe rectangular opening in the bottom of the Fibre Channel Option and insertthe SFP transceiver connector end first. Then carefully guide the SFP trans-ceiver into the FCO until it clicks into place. Refer to Figure 4-16.Small circuit board is facing youwhen oriented correctly for insertion.Figure 4-15 End View of Small Form Factor Pluggable TransceiverRectangular opening in bottomof Fibre Channel Option. SFP adapter fully insertedinto Fibre Channel Option.Figure 4-16 Inserting SFP Adapter into Fibre Channel Option4.6 Initializing the Fibre Channel OptionAfter physically installing the Fibre Channel Option onto the library, disconnect (ifconnected) the Fibre Channel Option from the FC host or Hub to avoid affecting anyoperational systems.NOTERefer to the applicable TLS Installation and Operation manual for instructions on using the TLSLibrary and its menus.501440 Rev. J FCO Type C Installation 4-15
