AC Power ReceptaclePower SwitchSCSI 0SCSI 4SCSI 2SCSI 1SCSI 5SCSI 3SERIALFAIL OVERETHERNETFIBRE CHANNEL 0FIBRE CHANNEL 1SCSI 0LEDSCSI 4LEDSCSI 2LEDSCSI 1LEDSCSI 5LEDSCSI 3LEDAT LED 1(Fibre Channel 1)LK LED 1(Fibre Channel 1)AT LED 0(Fibre Channel 0)LK LED 0(Fibre Channel 0)ST LED(Ethernet)LK LED(Ethernet)ST LEDFT LEDFigure 9-5 Rear View of the Type B Fibre Channel Bridge/Router (FCO)1. Remove power from the FCO: first turn the power switch off and then remove thepower cord.2. Remove power from the TLS: first turn the power switch off and then remove thepower cord.3. If the FCO is connected the FC host or Hub, disconnect it.4. Disconnect any SCSI cables (SCSI 0 through SCSI 5) from the rear of the FCO.5. Disconnect the cable from the serial connector on the FCO.6. If the FCO is mounted in a rack, cabinet or other location detach it and it will beready for packing.9.4 Preparation for Packing ATTO Fibre Channel OptionsCAUTIONBe sure to turn the library’s power off before installing or removing a Fibre Chan-nel Option.501440 Rev. J Repacking 9-5
