Pronto! 482/486/682/863 9-11CleaningDuring the normal operation of the cutter, particles of dust and paper canaccumulate inside the cutter. Remove these particles with a soft brush or avacuum.When cutting through the label material instead of the label gap remains ofadhesive may accumulate on the blades. If operating in backfeed mode, suchremains of adhesive may be deposited on the drive roller as well.Therefore both, the drive roller and the cutter blades, must be cleaned often.1 Loosen the screw (1) and remove the cutter from the printer.2 For cleaning the drive roller open the print head and remove the mediafrom the printer.3 For cleaning the circular blade you can turn the axle (3) with ascrewdriver for slotted head screws (slot width 7 mm).1 Remove all deposits both at the drive roller and the cutter blades withisopropyl alcohol and a soft cloth.Warning: Before starting any maintenance, turn the printer OFF anddisconnect the printer from the electrical outlet!Caution: Risk of injury! The cutter blades are sharp!Note: With the screw (2) the rotation angle of the circular blade is limited to120°. If you could not remove all pollutions from the circular blade you canloosen the screw (2) about 5 mm from the profile to turn the axle (3) 360°.
