Quintum Tenor AX Product Manual

Also see for Tenor AX: Product guide Quick start guide

Contents

Quintum Tenor AX Product Manual Manual pdf 78 page image

5-9 P/N 480-0062-00-10Chapter 5: Advanced Topic: Diagnostics/MaintenanceMaintenance ProceduresThe following are advanced maintenance procedures you can perform through the Command LineInterface (CLI) or through the Tenor Configuration Manager. See the applicable user documentationyou received with the unit for detailed information.NOTE: The instructions below are given for the Command Line Interface (CLI). You can alsoaccomplish the tasks through the Tenor Configuration Manager. See the user documenta-tion you received with the unit for detailed information.Restore Factory DefaultsA factory default is a default setting that is configured in the factory before the unit is shipped. Wedo not advise that you reset the system back to factory defaults unless advised to do so or if yoursystem becomes corrupted.If you choose to restore the factory defaults, all current configuration will be deleted, including yourpassword. Restoring factory defaults does not change or delete the Tenor’s IP address, subnet maskor default gateway; you will still be able to communicate with the unit after a reset.You can set all system configuration settings back to their factory defaults through the CommandLine Interface (CLI) as follows:1. Access the CLI through a Telnet session. See the Command Line Interface (CLI) guide for moreinformation.2. Access the Config-VOIPNetwork-1 prompt.3. Type setfactory. You will be asked if you are sure you want to set the unit back to factorydefaults.4. Type yes to confirm (type no to cancel the restore).Reset SystemThe Reset system feature enables you to reset the system, including hardware and software. You canreset the system through the unit’s Back Panel or through the Command Line Interface (CLI).Back Panel. Use a blunt, thin object to press in the Reset button, located on Tenor AX’s front panel.The system will reset.Command Line Interface (CLI). You can reset the system through the Command Line Interface(CLI) as follows:1. Access the CLI through a Telnet session. See the Command Line Interface (CLI) guide for moreinformation.2. Access the Maintain-MasterChassis-1# prompt.