P/N 480-0062-00-10 6-15Chapter 6: Advanced Topic: SNMP/IVRConfigure IVR - Quick StartFor a Tenor AX to be used as part of the complete IVR system, and communicate effectively with theRADIUS, you must configure basic options in the Tenor AX through the Command Line Interface(CLI) for the following:• Basic IVR Data• RADIUSInstructions for configuring basic IVR information via Command Line Interface (CLI) are describedbelow. For detailed information about all CLI commands available for IVR and detailed informationabout the command described below, see the Command Line Interface guide you received with theunit.Basic IVR Data (via Trunk Group)Configure basic IVR information as follows:1. Access CLI.2. Access the config-trunkcircuitroutinggroup-1# prompt.3. Type set ivrtype 2 (sets the IVR type to pre-paid calling services).4. Type set ivraccessnumber, followed by the telephone number used to access the IVR system (upto 14 digits).5. Type ivrcardlength 10 (10 is an example, the length of the calling card is numeric up to 20 dig-its).6. Access the applicable config- trunkcircuitroutingroup-1# prompt.7. Set the ivrlanguage field to the applicable language: 0 (English), 1 (Persian), 2 (Mandarin), or 3(French), 4 (Spanish), 5 (German), or 6 (Arabic).RADIUS ServerConfigure RADIUS data via config radius# prompt as follows:1. Access CLI.2. Access the config-radius-1# prompt.3. Type set psipa, followed by the IP address for the primary RADIUS server (i.e., set psipa208.22.234.34). The “p” indicates the primary RADIUS server.4. Type set ssipa followed by the IP address for the secondary RADIUS server (i.e., set ssipa208.22.234.32). The “s” indicates the secondary RADIUS server.
