RCA J12H770 User Manual

Contents

19Chapter 5Chapter 5: Commercial Interface MenusCommercial InterfaceOnCommercial InterfaceClone ManagementChannelOSDSourceVolumePower ManagementKey ManagementReset Commercial InterfaceMENU ExitSelectFF GGGGGGGGGGGGGGGGGG- You must set “Commercial Interface” to “On” to activate the below items.Commercial InterfaceOnCommercial InterfaceClone ManagementChannelOSDSourceVolumePower ManagementKey ManagementReset Commercial InterfaceMENU ExitENTER OK SelectFF GGGGGGGGGGGGGGGGGGCommercial InterfaceOnVirtualOffOffDirect Tuning AccessATSC Tune ModePower On SourcePower On Major ChannelPower On Miner ChannelChannel HoldMENU BackSelectFF GGFF GGFF GG20FF GGChannelThese TVs include a full commercial interface that allows your facility to customize the performence to yourspecific needs. These settings are only accessible to the installer with the use of the Master Remote(R130K2).Contact your RCA Commercial Distribution to obtain a master remote.You can access this menu by pressing MENU -> 9 -> 6 -> 3 -> 2 using the Master Remote.Commercial InterfaceOnCommercial InterfaceClone ManagementChannelOSDSourceVolumePower ManagementKey ManagementReset Commercial InterfaceMENU ExitENTER OK SelectFF GGGGGGGGGGGGGGGGGGCommercial InterfaceOn60SChannel BannerOSD TimerClear V-ChipMENU BackSelectFF GGFF GG- Channel Banner : If this function is off then channel banner will not appear when channel is changed.- OSD Timer : Use this setting to configure the menu OSD time out.- Clear V-Chip : This function can be used to Clear V-Chip password and settings.OSD- Direct Tuning Access : If this function is on, you can tune to channels even if the channels are not in thechannel list using the numeric keys. If this function is off, only channels in the channel list can be tuned.- ATSC Tune Mode : This function sets the channel frequency type for Digital Channels to physical or virtual.If the facility has a head end signal distribution system, set this to “physical”.- Power On Source : Use this setting to configure the signal source of the TV when it is turned on.- Power On Major/Minor Channel : Use this setting to configure the initial channel of the TV when it isturned on.Note: “Power On Source” should be set to “TV” to use this setting.To tune to an analog channel, set minor channel to 0.- Channel Hold : If this function is on then you cannot change channels.