Graphics contained within this publication are for representation only.Chapter 5 31Other InformationChapter 5: Other InformationModes of operationThe ClonePRO operates from one of two modes:DSCI Connect a DSCI cable to the ClonePRO and to the TV’s DSCI porton the back panel.IR (Infrared) This operation is wireless. Press ON to begin using theremote in IR mode.The corresponding “ready” light indicates the mode of operation, and thecorresponding “busy” light indicates activity in this mode.Buttons with black labels function similarly in both modes, while green labelsoperate DSCI mode and red labels operate IR mode.DSCI modeThe ClonePRO enters this mode when it is connected to the TV’s Digital SerialCommunications Interface port via a cable (included).• Any standard (no-flip, 1-to-1) 8-conductor computer-networking cablemay be used.• No battery is required in this mode.• If the unit is already in IR mode, press OFF to speed the transition toDSCI mode.Using the ClonePRO™DSCI (green) buttonsComm Restores the TV to normal commercial operation, essentially undoing the effect of the Legacy and Decom buttons.Decom “Decommercializes” the TV to facilitate aftermarket resale.[Factory] Press and hold the RESET button for several seconds to re-initialize the TV, reverting all settings to factory defaults.Note: Pressing FACTORY overwrites any settings already in the TV.LEARN Begins the process of learning the settings from a TV that has been setup as desired.Note: Pressing LEARN overwrites any settings already in the ClonePRO.Legacy Places the TV in a mode in which it emulates the behavior of older models. This is a required part of theconfiguration for some applications.POWER Turns on the TV. It is recommended, though not required, when in DSCI mode to view on-screen displays.[Status]: Press and hold the INFO button for several seconds to display settings stored in the ClonePRO and the TV. For example:Mem: CB:36 TV:36This tells you the ClonePRO and the TV have 36 pages of information stored in memory.Continues on next page...