Chapter 1: Connections and SetupChapter 1 3Graphics contained within this publication are for representation only.Things to Consider Before You ConnectProtect Against Power Surges• Connect all components before you plug any of their power cords into the wall outlet or power strip. NEVER plug yourmonitor into an outlet that is controlled by a wall switch.• Turn off the monitor and/or component(s) before you connect or disconnect any cables.• Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with yourmonitor.Protect Components from Overheating• Don’t block ventilation holes on any of the components. Arrange the components so that air can circulate freely.• Don’t stack components.• When you place components in a stand, make sure you allow adequate ventilation.• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow aroundother components.Important Stand and Base Safety InformationIf a stand or base is used insure that it is of adequate size and strength to prevent the TV from being accidentally tippedover, pushed off, or pulled off. This could cause personal injury and/or damage the TV. Refer to the Important SafetyInstructions packed separately.Position Cables Properly to Avoid Audio Interference• Insert each cable firmly into the designated jack.Use Indirect LightDon’t place the monitor where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.Connection IllustrationsThe components used in the connection illustrations are for representation only.Receiving ChannelsIn order for your Plasma Monitor to display television programming, you must connect a component than can receiveprogramming (e.g. satellite receiver, HD receiver, or cable box).STOP PAUSEMONITORON•OFFAUXDVD SAT•CABLERECORDPLAY FORWARDREVERSEAUTO SETCINEMAMUTEINFOMENUOKCLEARGUIDEANTENNA1 2 34 5 67 8 90INPUTVCR 1AVCR 2CH+CH–VOLVOLGO BACKREPEAT AUDIO ANGLE OPENZOOMu n i v e r s a lDVDRemote Control2 AA batteries Power cordCheck Supplied PartsCheck that the following parts werepacked with your product.