RCA RCU1010RF User Manual

Also see for RCU1010RF: Quick start guide Quick start guide

Contents

RCA RCU1010RF User Manual Manual pdf 10 page image

The RCU1010RF remote can control up to nine components. In order for the RCU1010RF to control yourcomponents (TV, VCR, PVR/DVR, DVD, etc.), you must program it with the corresponding code entryfrom the Code Lists. This enables the remote to control your component with the proper commands. Ifyour TV, VCR, DVD, or satellite receiver is an RCA, ProScan or GE brand, the RCU1010RF may not needany programming to control it.To program the remote with the codes for your components, you can use one of three methods: Code ListEntry, Code Search or Code Autosearch. Use the Code List Entry method first, as this is the quickest andeasiest method. The Code Search method may require up to 300 keypresses, and the Code Autosearchmay take some time to cycle through all available codes.During all code entries, the remote control unit must be pointing at the component you are programming.While programming your remote, you may wish to extend the LCD touchscreen display time (see LCDTouchscreen Display Time section on pgs. 27-28).Code EntryYou can enter codes in your RCU1010RF from the Code Lists using the SETUP key. (Refer to the Code Listsof the most popular brands at the end of this User’s Guide.) When you enter a valid code for any given mode(e.g., when you enter a valid code for a TV), the default key labels are displayed on the touchscreen, and anyCode List Entry10RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 10