RCA RCU1010RF User Manual

Also see for RCU1010RF: Quick start guide Quick start guide

Contents

RCA RCU1010RF User Manual Manual pdf 31 page image

31The RCA All Power Off feature is available in all normal operating modes. If the ON•OFF key on therubber keypad is pressed twice consecutively (within two seconds), all RCA equipment is turned off.The touchscreen shows the Power Off Screen while this routine is active.RCA All Power Off FeatureAUDIO FEATURESAM•FM KEYThe AM•FM allows you to select the AM or FM band on your AUDIO system.CENTER, FRONT, REAR & TEST KEYSYou can adjust the levels of the center, front and rear speakers by using the LCD UPARROW/DOWN ARROW keys. The TEST key is used when you make speaker balanceadjustments to maximize the performance of your AUDIO system.CD, TAPE, TUNER, TV, VIDEO KEYSUse the CD, TAPE, TUNER, TV and VIDEO keys to select the component you want to control.DSP KEYWhen the Digital Signal Processing (DSP) Mode is enabled, pressing this key allows youto cycle through the various DSP Modes.UP ARROW / DOWN ARROW KEYSThe UP and DOWN ARROW keys are used to make adjustments on delay time, centerspeaker output level, rear speaker output level, front speaker level or subwoofer level.PROG KEYThe PROGRAM key is used to program your AUDIO preset channels.BACKLIGHT KEYThe BACKLIGHT key turns the LCD and key backlighting on or off.COMPONENT KEYSThe component keys on the LCD change the component currently being controlled by the remote(e.g., TV, VCR, CABLE, SAT, DVD, AUDIO 1, 2, 3, 4). The AUDIO 1-4 keys allow you to programyour CD, TUNER, TAPE and AMP player. (Note: The VCR key is used for PVR/DVR.)ENTER KEYThe LCD ENTER key is used to complete channel selections for some brands of TV’s. It is also usedto complete the highlighted sections when navigating through new screens.GO BACK KEYThe GO BACK key allows you to go to the previous channel you selected. It operates the sameas the Last Channel, Previous Channel or Recall keys on your existing remote.GUIDE KEYIf your component is equipped with this feature, the LCD GUIDE key brings up the on-screenprogram listing.INPUT KEYThe LCD INPUT key selects the video inputs of your component, if the component is equippedwith this feature.LEARNThe LEARN feature is used to supplement the preprogrammed Code Lists. The standard Code Listsprovide most of the functions needed, but you can add a small number of additional functions ofyour choice.LED INDICATOR LIGHTThe Light Emitting Diode (LED) indicator light, located at the upper right-hand side of the RCU1010RFunit, lights up whenever a rubber key or any LCD touchscreen key is pressed. The LED indicator lightflashes and beeps three times (approximately two seconds) to indicate any error condition.LIQUID CRYSTAL DISPLAYThe Liquid Crystal Display (LCD) acts as the “virtual keypad” on the remote. The touchscreen isnormally blank when the remote is not in use. Pressing the SETUP or BACKLIGHT key, or touchinganywhere on the LCD, turns the display on. The remaining rubber keys do not activate the display.NOTE: Please use only your finger to touch the LCD screen. Sharp objects may cause scratches or cracks.Glossary Of TermsGlossary of TermsRCU_1010_RF_IB_RevA.qxd 9/24/03 10:31 AM Page 31