15Note: To reset the current key labels within a component totheir default settings, press and hold the current componentkey for three seconds. Resetting any key label within acomponent to its power-on default setting results in anautomatic save for that mode. This will not affect yourprogram codes or any Learned commands. Performing thisreset will not reset the component key back to its defaultsetting. This must be done by following the steps in theChange LCD Component Key Labels section above.5. Press and release any of the LCD panel keys within the currentmode repeatedly to select the desired key label. Each time youpress a key, a different label for that key is displayed.6. To save your new key label selections for the current mode,press and release another component key or the SETUP key.The display shows the Confirm to Save Screen. Press andrelease the LCD OK key to save or the LCD EXIT key todelete the changes you have made.7. If you pressed another component key in step 6, those keylabels are now displayed and you can proceed to renamethem, if desired.8. If the SETUP key was pressed in step 6, the screen returnsto the Key Label Options? Screen.9. The relabeling of keys is complete. To exit the Setup Mode,press and release the LCD EXIT key, followed by the LCDOK key on the Exit Setup Screen.RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 15
