ESP-SMTe Controller20Manual WateringStart watering immediately for selected zones or for allzones.cb NOTE: If Manual Watering is started during automaticirrigation, the watering schedule is canceled for theday and resumes on the next Allowed Watering Day.Turn the dial to Manual Watering.Water Individual ZoneA Select Water Individual Zone from the ManualWatering screen.cb NOTE: A selected zone will be activated even if it isnot ENABLED. A zone that does not have an associ-ated station module will display No Module.B Select the desired zone; then press NEXT.C Set the run time for the selected zone; then pressNEXT.Water All ZonesA Select Water All Zones from the Manual Watering screen.cb NOTE: All zones will be activated even if they are notENABLED. Zones will not activate that do not have anassociated station module installed.B Set the run time for all zones; then press START.Water Selected ZonesA Select Water Selected Zones from the ManualWatering screen..cb NOTE: Selected zones will be activated even if theyare not ENABLED. Zones that do not have an associ-ated station module will display n/a.B Select the desired zone or zones.C Set the run time for every desired zone; then pressNEXT until you reach the end of your available zones.D NEXT will change to START; then press START.During All Manual Watering:The Watering - Manual screen shows the current zone andtime remaining.A Press – or + to adjust the time remaining if desired.B Press ADV. ZONE to advance to the next zone ifdesired.C To cancel watering, press CANCEL or turn the dial toOFF for three seconds and then return the dial to theAUTO RUN position.