APPENDIX E: TROUBLESHOOTING 83Event Log File and On-Screen Error CodesDominion KSX will display or log an error code in the Dominion KSX Event Log Screen in theevent of a problem occurring. Error codes are eight-digit hexadecimal numbers, containing twoparts: the first four denote error type; and the second four digits denote a location code.These last four digits of the Dominion KSX error code are the most useful in determining whathas caused a system failure. Below is a list of location codes (the last four digits of an error code),and their meanings.ERROR CODE( LAST 4DIGITS)M EANING RECOMMENDATION0001 – 0003 Memory allocation error Reboot Dominion KSX. Make sure the BIOS memory testrecognizes at least 64MB of RAM. If the problem persists,restore the software and file system from the RecoveryCD-ROM.0004 Could not read the onfigurationfile on startup. The file may becorrupt, the file system may bedamaged, or the config filemight be from an older versionof Dominion KSX.Reenter the configuration information and reboot. If theproblem continues, restore the software and file systemfrom the Recovery CD-ROM.0005 The config file was missing.This may be the first time youhave started Dominion KSX orthe file system has becomecorrupt.Reenter the configuration information and reboot. If theproblem continues, restore the software and file systemfrom the Recovery CD-ROM.0006 The config file could not besaved. The file system may becorrupt or the hard drive maynot be responding.Retry, but if the problem persists, restore the software andfile system from the Recovery CD-ROM.0007 – 0008 Memory allocation error. Reboot Dominion KSX. Make sure the BIOS memory testrecognizes at least 64MB of RAM. If the problem persists,restore the software and file system from the RecoveryCD-ROM.Delete Memory allocation error. Reboot Dominion KSX. Make sure the BIOS memory testrecognizes at least 64MB of RAM. If the problem persists,restore the software and file system from the recovery CD-ROM.0009 Could not find the frame rabbercard.Power off the system and make sure the frame grabbercard is inserted firmly. If the problem persists, there maybe a problem with your Dominion KSX hardware.000A Frame grabber card is notresponding correctly.Power off the system and make sure the frame grabbercard is inserted firmly. If the problem persists, there maybe a problem with your Dominion KSX hardware.000B Memory allocation error. Reboot Dominion KSX. Make sure the BIOS memory testrecognizes at least 64MB of RAM. If the problem persists,restore the software and file system from the RecoveryCD-ROM.000C – 000F Memory allocation error. Reboot Dominion KSX. Make sure the BIOS memory testrecognizes at least 64MB of RAM. If the problem persists,