Chapter 2: Installation and Configuration26Note: If you are using virtual media, you must use the USB connection.Diagram key for PS/2 connectionsKX II-101-V2Target serverLocal monitorLocal mouse and keyboard (optional)Video connection from the KX II-101-V2 to thetargetKVM cable connection from the KX II-101-V2to the target serverOptional KX II-101-V2 to monitor connectionOptional PS/2 to USB adapter connection(cable not included) from target to keyboardand mouseC: NetworkConnect a standard Ethernet cable from the network port labeled LAN toan Ethernet switch, hub or router. The LAN LEDs that appear above theEthernet connection indicate Ethernet activity. The yellow one blinkswhile the KX II-101-V2 is in use, indicating IP traffic at 10 Mbps. Thegreen light indicates a 100 Mbps connection speed.D: Admin PortThe Admin port enables you to perform configuration and setup for theKX II-101-V2 using a terminal emulation program like HyperTerminal.Use one DB9M to DB9F straight serial cable to connect from the KX II-101-V2 to the serial port on your PC or laptop. The serial portcommunication settings should be configured as follows: 115,200 Baud 8 data bits 1 stop bit No parity No flow control
